Repairing The Air Inlet Valve; Repairing The Air Inlet Valve - Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List

SECTION 6: MAINTENANCE
IMPORTANT
DO NOT let loose parts fall into the air
inlet.
NOTE
Valve is under spring tension
NOTE
Use all of the parts provided in the kit
regardless of the replaceable part's
condition.
PAGE - 76
®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
4. Seat a new filter element [C] onto the filter
mounting posts [D].
5. Replace cover [B] and wing nuts [A].
6. Close the hood.
7. Dispose of discarded filter within the
guidelines of all applicable local, regional
and/or federal laws.

6.6.2 REPAIRING THE AIR INLET VALVE

Should a condition occur that requires air inlet valve
maintenance (see
Guide), a repair kit is available. To repair the air inlet
valve, order air inlet rebuild kit no. 264154-102. Refer to
Figure 6-4, and the following procedure:
TOOLS/ITEMS NEEDED
Hex Head Screwdriver
or Wrench
Adjustable Wrench
1. Shut down machine and lock out all power, as
per the Safety Section of the manual.
2. Locate the compressor's air filter
compartment housing and remove the two
(2) wing screws [A] from cover [B].
3. Remove air filter [C], and put it aside
temporarily so it will not get damaged or
soiled; the full air filter inlet valve [D] is now
accessible.
4. Remove the two (2) nuts [E] and two (2)
washers [F] from the mounting posts [V].
5. Grasp the governor body [P] and pull upwards
to disengage the valve from its seating.
6. Disassemble the valve and replace used parts
with new parts found in the kit. Refer to
Figure 6-4 to assure correct part positions
for re-assembly.
7. Once the valve's parts have been replaced
with the kit parts and re-assembled, place
the rebuilt, complete inlet valve assembly
back into position on the mounting posts [V].
8. Replace the two (2) nuts and two (2) washers
[F] on the mounting posts [V], and tighten
securely.
9. Replace the air filter [C], or exchange it for a
new one if air filter is soiled (refer to Section
090034-OP_r0
Section 7.2, Troubleshooting
REPLACEMENT
PART(S)
Air Inlet Rebuild Kit
No. 264154-102
®