Ac Voltage Outlets; Generator Control On/Off Toggle Switch; Dc Charger Mode Toggle Switch; Volts/Amps Manual Adjustment Dial - Vanair AIR N ARC RELIANT 250 Series Operations Manual & Parts List

SECTION 2: DESCRIPTION
page - 30
AIR N ARC
Do not force the reset buttons if they remain fixed in their
inset positions—if the buttons are tripping frequently, or
do not reset, this is an indication of a system problem.
Whenever a circuit breaker trips, always check the
complete system for any possible faulty conditions before
resetting the system. If trouble persists, consult Section
7, Troubleshooting, or the Vanair

2.5.6 AC VOLTAGE OUTLETS

The AC voltage outlets allow for AC generator power
access via one 120V duplex, and one 240V receptacles.
2.5.7 GENERATOR CONTROL ON/OFF TOGGLE
SWITCH
The generator control ON/OFF switch engages the AC
generator. When off, the outlets are de-energized.

2.5.8 DC CHARGER MODE TOGGLE SWITCH

The three-position DC charger mode toggle switch lets
the operator choose the type of charge needed from 12V
center (default), 12V boost or 24V boost options. This is
a momentary switch; the lights will indicate the mode
selected.

2.5.9 VOLTS/AMPS MANUAL ADJUSTMENT DIAL

The volts/amps manual adjustment dial allows the
operate to manually increase or decrease the amount of
amperage or voltage, in variable increments, for the
desired weld heat. Range is: 30-205 amps / 15-40 volts.

2.5.10 COMPRESSOR AIR GAUGE

The compressor air gauge indicates the discharge air
pressure.

2.5.11 BATTERY CABLE RECEPTACLE

The battery cable receptacle junction contains the
interface connections for the battery cables when
charging the battery from the DC charger. The battery
cable receptacle contains a weather-resistant cap.

2.5.12 WELDER LEAD CONNECTION

The welder lead connection contains the positive and
negative interface connections for the standard welding
lead cable.
090019-OP_r0
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
Service Department.
®