Table of Contents
Advertisement
Industrial Gaussmeter IGM11 Operating Instructions
Chapter 9 Serial Interfaces
9.12 SCPI Command Reference
9.12.1 Control Commands
9.12.1.1 *RST
Description:
Mode:
Parameter:
Response:
*RST
Example:
9.12.1.2 *CLS
Description:
Mode:
Parameter:
Response:
*RST
Example:
9.12.1.3 *ESE[?]
Description:
Mode:
Parameter:
Response:
*RST
Example:
Reset Command
The gaussmeter is reset to default values. The internal parameters
are set to default values. A complete reset of the device is carried
out. Since the device interface is also reset, further commands on this
interface might get lost.
Command
none
none
value:
not relevant
send
Clear Status Command
Reset all event registers.
Command
none
none
Value:
not relevant
send
Standard Event Status Enable Command
Set or Query the standard event register. The gaussmeter displays a
decimal value that corresponds to the sum of the binary place values
of all set bits in this register.
Command and query
{<Value>} within the range of 0..255
Standard event register
Value:
not relevant
send
send
receive
*RST<LF>
*CLS<LF>
*ESE 22<LF>
*ESE?<LF>
22<CR><LF>
magne t
MAGSYS
systeme
Page 71 / 106
Advertisement
Table of Contents
