Summary Of Scpi Commands; Control Commands; Main Commands - MAGSYS IGM11 Operating Instructions Manual

magne t
MAGSYS
systeme

9.11 Summary of SCPI Commands

The following conventions are used in the SCPI command syntax:
•
•
•

9.11.1 Control Commands

*CLS
*ESE?
*ESR[?]
*IDN?
*OPC?
*OPC
*RST
*SRE[?]
*STB?
:STAT:PRES
:STAT:QUES:ENAB[?]
:STAT:QUES:EVEN?
:STAT:MEAS:ENAB[?]
:STAT:MEAS:EVEN?

9.11.2 Main Commands

:MEAS?
:READ?
:UNIT
:UNIT?
:MODE {DC|AC|PEAK}
:MODE?
:RANG:SET {0|1|2|3}
:RANG?
:NULL
Page 68 / 106
Optional key words or parameters are issued in square brackets [ ]
Parameters within a command character string are issued in braces { }
The parameter issued in angle brackets < > must be replaced by a value.
{
TESL|APM|GAUS|OE|G|
}
T|O|A
Gaussmeter IGM11 Operating Instructions
Chapter 9 Serial Interfaces
Reset all event registers
Query the event release register
Set or query the standard event register
Query identification
Return "1" for synchronization
Set the event bit "Operation terminated"
Reset the gaussmeter
Set or query the sum release register
Query the sum register
Reset the error byte release register
Set or query the error data event release
register
Query the error data event register
Set or query the measurement event release
register
Query the measurement event register
Query the current measuring value
Query the current measuring value
Set or query the physical unit
Set or query the DC or AC field operating
mode
Set the measuring range
Query the current measuring range
Null compensation of the measuring probe