Display - MAGSYS IGM11 Operating Instructions Manual

Industrial Gaussmeter IGM11 Operating Instructions
Chapter 5 Operation

5.2 Display

The following shows a typical display sample.
Measuring
Value
with Unit
Measuring Value with Unit
Measuring Range and Mode
Status of the Digital Inputs / Outputs
Lifesign
Status Signal
Error Message
Lifesign
Measuring Range
and Mode
Figure 12 Display
Output of the actual measuring value with the
corresponding physical unit. With range overflow the
message −OL− is issued.
Output of the actual measuring range, physical unit and
measuring mode.
The actual state of the digital inputs and outputs is
permanently issued:
on the left: inputs 1 to 3
•
on the right: outputs 1 to 4
•
An active input or output is shown invertedly.
For easy evaluation of the functioning, this field flashes
once per second.
This shows e.g. an active LAN access.
This message appears, if an internal error or an interface
error has been detected.
The detailed error states can be queried via the interfaces
or the set-up menu.
MAGSYS
Status Signal
Error Message
Status of the Digital
Inputs- / Outputs
magne t
systeme
Page 25 / 106