KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 91

Step 38: Attach Ground Stake to TNR Upright
A: In the spot shown in fig. 38.1 drive 1 Rebar Ground Stake 13" (330mm) into the ground against the (8965)
TNR Upright. Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off.
B: Attach the ground stake to (8965) TNR Upright just below the TN1 T-nut using 1 (S7) Pan Screw as shown
in fig. 38.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth
any sharp edges from impact area and touch up with outdoor paint.
Fig. 38.1
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 13" (330mm)
into ground. Digging or driving stakes can be
dangerous if you do not check first for under-
ground wiring, cables or gas lines.
Hardware
1 x Pan Screw
S7
91
T-Nut
8965
13" In Ground
(330 mm)
Other Parts
1 x Rebar Ground Stake
•See details
Fig. 38.2
S7
Rebar
Ground
Stake