KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 59

Step 19: Rock Wall Assembly
Fig. 19.1
2779
S20
x 4 per
board
Complete Step 19, A-E twice to make 2 Rock Wall Assemblies.
A: Lay 2 (2776) Rock Rails down, side by side with angled edges
facing down. (fig. 19.1)
B: Place (2779) Access Board on the bottom of each (2776) Rock
Rail as shown in fig. 19.1. Make sure (2779) Access Board is flush to
the outside and bottom edges of each (2776). Attach using 4 (S20)
#8Wood Screws.
C: 7-5/8" (194mm) down from the top of both (2776) Rock Rails place
1 (2781) Rk Board B, making sure the sides are flush to the outside
edges of each (2776) Rock Rail. Attach using 4 (S20) Wood Screws.
(fig. 19.1)
D: In between the (2779) Access Board and (2781) Rk Board B
stagger 2 (2781) Rk Board Bs and 2 (2780) Rk Board As using 4 (S20)
Wood Screws per board. Placing them as shown in fig. 19.1, this will
prevent rocks from forming a straight line. Make sure the boards are
evenly spaced and do not exceed 2-3/8" (60mm) between boards.
FW0
BN1
Wood Parts
2 x Access Board
2779
6 x Rk Board B
2781
4 x Rk Board A
2780
4 x Rock Rail
2776
2780
2781
Note: Gaps between boards 2-1/4"
(57mm), not to exceed 2-3/8" (60mm)
LW1
PB2
S10
Rock
48 x
10 x
10 x
2780
2781
Fig. 19.3
E: Place 1 rock on each (2780) Rk Board A
and (2781) Rk Board B (fig. 19.2) and attach
using 1 (PB2) Pan Bolt (with lock washer,
flat washer and barrel nut) and 1 (S10) Pan
Screw per rock. The Screw must be in the
hole directly under the Pan Bolt, it will stop the
rock from spinning. (fig. 19.3)
Hardware
Wood Screw
S20
Pan Screw
S10
Pan Bolt
PB2
(LW1 lock washer, FW0 flat washer & BN1 barrel nut)
59
Note: The holes
in the rock boards
2776
must orient to the
2781
top of the boards.
7-5/8" (194mm)
Approx
Fig. 19.2
Other Parts
10 x Rocks (6 green/4 yellow)