KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 49

Step 15: Install Ground Stakes
A: In the 6 places shown in fig. 15.1 drive the Rebar Ground Stakes 13" (330mm) into the ground against all 4
(2607) Diagonals and both (2613) Heavy SW Posts. Be careful not to hit the washer while hammering stakes into
the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) Pan Screw per ground stake. (fig. 15.2)
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
must be driven 13" (330mm) into ground. Digging or driving stakes can
be dangerous if you do not check first for under-ground wiring, cables
or gas lines.
Fig. 15.1
2613
SEE FRONT COVER
FOR SAFETY CLEARANCE
Warning!
To prevent tipping and avoid potential injury, stakes
2607
Swing Wall
Front
Swing Wall
Hardware
6 x Pan Screw
S7
49
Fig. 15.2
S7
Rebar
Ground
Stake
Other Parts
6 x Rebar Ground Stake
2607