KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 88

Step 35: Attach TNR Brace Assembly
A: Use (8965) TNR Upright as a guide to judge the proper bolt location, remove the bottom pan bolt and nut.
The bolt will no longer be needed, but keep the lock nut. (fig. 35.1 and 35.2)
B: Attach the top of the TNR3 Post Mount to TNR2 Slide Clamp Ring using 1 (PB2) Pan Bolt (with the
previously removed TN1 lock nut and 1 FW1 flat washer). (fig. 35.2)
C: Insert TNR3 Post Mount on (8965) TNR Upright, pre-drill with a 1/8" (3.2mm) drill bit then attach with 2 (S6)
Pan Screws. (fig. 35.2)
D: Attach (8963) TNR Ground Brace flush to the bottom of (2770) End Panel Left with 2 (S11) Wood Screws
and 1 (S4) Wood Screw. (fig. 35.1 and 35.3)
Fig. 35.1
2770
Remove PB1 (Pan Bolt)
first then install PB2
(Pan Bolt with previously
removed LN1 lock nut)
Remove H9 (Hex Bolt)
first then install TNR
Brace Assemlby with
8965
Wood Screws as noted in
Fig. 35.3
TNR Brace
Assembly
Hardware
1 x Pan Bolt
PB2
1 - (FW1 flat washer, LN1 lock nut - previously removed)
2 x S6 Pan Screw
1 x Wood Screw
S4
2 x Wood Screw
S11
Fig. 35.2
TNR2 Slide
Clamp Ring
PB2
Fig. 35.3
S11
88
LN1
FW1
8965
S6
2618
S4
Other Parts
1 x TNR3 Post Mount
TNR3 Post
Mount
8963