KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 108

Step 46: Sunburst Assemblies
A: From inside Unit A place 1 (9082) MOD Sunburst Bottom against the (2760) Roof Supports on the Roof
Assembly opening on the Front Wall. Make sure it sits tight to the Roof Assembly on each side then attach with 2
(S20) Wood Screws. (fig. 46.1 and 46.2)
B: Centre (8305) Starburst Centre lengthway on the outside of (9082) MOD Sunburst Bottom then measure
1-1/4" (32mm) up from the bottom of (9082) Sunburst Bottom and attach (8305) Starburst Centre with 2 (S20)
Wood Screws. (fig. 46.1 and 46.3)
C: On the inside of the assembly place (9080) MOD Sunburst A tight to the top of (9082) MOD Sunburst Bottom
so the tip is centred at the peak of the Roof Assembly then attach to each (2760) Roof Support and (8305)
Starburst Centre with 3 (S20) Wood Screws. (fig. 46.1 and 46.2)
D: Place 1 (9081) MOD Sunburst B tight to each side of (9080) MOD Sunburst A and tight to the top of (9082)
MOD Sunburst Bottom then attach to each (2760) Roof Support and (8305) Starburst Centre with 2 (S20) Wood
Screws per board. (fig. 46.1 and 46.2)
E: Repeat Steps A - D on Unit B Roof Assembly for the opening on the Side Wall.
Unit A
Fig. 46.1
Front Wall
Fig. 46.2
Inside View
9081
S20
x 11
2760
Wood Parts
4 x MOD Sunburst Bottom
9082
4 x Starburst Centre
8305
8 x MOD Sunburst B
9081
4 x MOD Sunburst A
9080
9080
9081
9082
44 x
9082
2760
Hardware
Wood Screw
S20
108
Unit B
Side Wall
Fig. 46.3
Outside View
8305
1-1/4"
32mm