KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 40

Step 9: Tunnel Assembly
Part 1
A: Bend all 4 MOD Tunnel Panels as shown in fig. 9.1.
B: Match 2 MOD Tunnel Panels together by making a slight "V" with the pieces so the peak of the "V" faces
away from you. Make sure connector tabs are coupled then straighten the 2 panels. Push down on one panel
and up on the other until you hear the connector tabs click together and the bottom edges are flush. You may
have to knock panels on a hard surface to align properly. (fig. 9.2 and 9.3)
C: Press nodules through the connector tab holes to hold Tunnel panels in place. (fig. 9.3)
D: Repeat Steps B-C to create a second Tunnel Side.
Fig. 9.1
Bend Here
MOD
Tunnel
Panel
Outside
View
Fig. 9.3
Nodule
Fig. 9.2
Inside View
40
Connector
Tabs
Other Parts
4 x MOD Tunnel Panels