KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 30

Step 4: Fort Assembly
Part 3
C: Loosely attach 1 (2607) Diagonal to left (2778) SW Ground MOD with 1 (H10) Hex Bolt (with lock washer, flat
washer and t-nut). (fig. 4.5)
D: Place each (2607) Diagonal tight and flush to the front of the Swing Wall then pre-drill pilot holes with a 3/16"
(4.8mm) drill bit and attach each (2607) Diagonal to the Swing Wall with 1 (LS3) Lag Screw (with flat washer) per
board, checking that they remain flush to outside edge. (fig. 4.5 and 4.6)
E: Repeat steps A-D to make a second Fort Assembly. Tighten all bolts in both assemblies.
Flush
Fig. 4.5
2607
TN1
(hidden)
LW1
H10
FW1
Fig. 4.6
FW1
LS3
2607
Wood Parts
2 x Diagonal
2607
Swing Wall
2778
2 x H10
4 x
LS3
Swing Wall
Hardware
Hex Bolt (LW1 lock washer, FW1 flat washer, TN1 T-nut)
Lag Screw (FW1 flat washer)
30
Flush
2607
LS3
FW1
2607