KidKraft Cedar Summit Kingsbridge Installation And Operating Instructions Manual page 46

Step 12: Swing End Assembly
A: Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) Hex Bolts (with LW2 lock
washer, FW2 flat washer and TN2 T-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of
angle. (fig. 12.1)
B: Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) Hex Bolts
(with LW2 lock washer, FW2 flat washer and TN2 T-nut). Tighten all bolts (fig. 12.1)
C: Install 2 (WB7) Wafer Bolts (with FW2 flat washer and TN2 T-nut) in the top bolt holes in (2615) SW Upright
as shown in fig. 12.1. IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Fig. 12.1
2613
Wood Parts
2 x Heavy SW Post
2613
1 x SW Upright
2615
1 x SW Support
2616
2616
TN2
FW2
LW2
G4
2 x G7 Hex Bolt (LW2 lock washer, FW2 flat washer, TN2 T-nut)
3 x Hex Bolt (LW2 lock washer, FW2 flat washer, TN2 T-nut)
G4
2 x Wafer Bolt (FW2 flat washer & TN2 T-nut)
WB7
TN2
2615
Hardware
46
FW2
WB7
G7
FW2
LW2
Notice 2 bolt
holes at top and
orientation of
the angle
TN2