KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 19

Step 6: Fort Assembly
A: With both the Left and Right Wall Assemblies facing each other, on the (A20) Corner Posts with the (A12)
Lower Diagonals, attach 1 (A24) Top Rope to the outside of the assembly with 2 (H5) 1/4 x 4-1/2" Hex Bolts
(with lock washer, flat washer and t-nut). (fig. 6.1)
B: On the opposite (A20) Corner Posts attach 1 (A17) Floor Front to the inside of the assembly with 2 (H6) 1/4
x 4-3/4" Hex Bolts (with lock washer, flat washer and t-nut). The Hex Bolts are installed from the outside of the
assembly. (fig. 6.1)
C: On the (A20) Corner Posts above the (A17) Floor Front attach 1 (A23) Acro Top with 4 (H5) 1/4 x 4-1/2" Hex
Bolts (with lock washer, flat washer and t-nut). This board should be flush to the tops of (A20) Corner Posts and
the extension should be on the Right Wall Assemby side. (fig. 6.1)
D: Attach 1 (A27) Top Back to the (A20) Corner Posts above the (A24) Tope Rope with 2 (H4) 1/4 x 4" Hex Bolts
(with lock washer, flat washer and t-nut) in the top holes. (fig. 6.1)
E: Make sure the assembly is square and then attach (A27) Top Back to the (A20) Corner Posts with 2 (S7) #12
x 2" Pan Screws (with 3/16" flat washer) in the bottom holes. (fig. 6.1)
Hex Bolt Assembly
Lock
Washer
Flat Hex
Washer Bolt
Wood Parts
1 x Top Rope 5/4 x 4 x 38-3/4"
A24
1 x Floor Front 2 x 3 x 38-1/2"
A17
1 x Acro Top 5/4 x 6 x 67-1/2"
A23
1 x Top Back 1 x 5 x 38-1/2"
A27
Step 3 Fort Assembly
T-Nut
Right Wall
Side
Hardware
6 x H5 1/4 x 4-1/2" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
S7
2 x #12 x 2" Pan Screw (with 3/16" flat washer)
2 x 1/4 x 4-3/4" Hex Bolt
H6
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H5
A23
H6
A17
A20
2 x
H4
19
A20
Fig. 6.1
A27
Left Wall
S7
Side
H4
A24 Notice hole
location towards
bottom both A24
& A17
H5
1/4 x 4" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)