KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 14

Step 1: Swing Beam Assembly
Hex Bolt Assembly
Lock
Washer
Flat Hex
Washer Bolt
A: In the middle holes of (A1)
CE SW Beam Back and (A2)
CE SW Beam Front install 2
Bolt-Thru Swing Hangers in
each beam (fig. 1.1) making
Step 14 Swing Asy A
sure the swing hangers are
oriented in the direction shown
in fig. 1.3 to maintain proper
swing motion.
B: Attach 1 Triangle Plate to the ends of each
(A1) CE SW Beam Back and (A2) CE SW
Beam Front using 1 (G1) 5/16 x 1-1/2" Hex
Bolt (with lock washer, flat washer and t-nut)
per Triange Plate in the hole indicated in fig.
1.2. Correct hole usage is very important.
Important!
Swing End
(With Overhang)
Wood Parts
1 x CE SW Beam Back 2 x 6 x 69-1/2"
A1
1 x CE SW Beam Front 2 x 6 x 69-1/2"
A2
T-Nut
Step 14 Swing Asy A
Make sure triangle is
tight against beam
H7
x 4
Bolt thru Hangers
Fig. 1.2
x 4
G1
G1
4 x
4 x
H7
Fig. 1.3
Fig. 1.1
C: Attach 1 (H7) 1/4 x 5-1/2" Hex Bolt (with lock washer,
flat washer and t-nut) to the ends of each (A1) CE SW
Beam Back and (A2) CE SW Beam Front . These bolts
do not attach to anything, but MUST be installed to the
beams to prevent splitting and checking of wood. (fig. 1.1)
Triangle Plates
Front
Hardware
5/16 x 1-1/2" Hex Bolt
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
1/4 x 5-1/2" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
14
Warning: For your childs safety,
orientate the swing hangers as
shown to ensure your swing will
have proper swing motion when
installed. Failure to do so could
result in premature failure of the
swing hanger or swing chain.
Front
A2
Back
A1
Back A1
Important!
Fort End Side
(No Overhang)
A2
Other Parts
4 x Bolt Thru Swing Hangers
1 x Triangle Plates (pkg of 4)