KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 33

Step 18: Attach Swing Assembly and Swings
MOVE FORT TO FINAL LOCATION. FINAL LOCATION MUST BE ON LEVEL GROUND
A: Attach Swing Assembly from Step 3 to (A31) SW Mount with 1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock washer,
flat washer and t-nut) and 1 (GL8) 5/16 x 2" Hex Bolt (with 2 flat washers and 1 lock nut) as shown in fig. 18.2.
B: See Swing Hanger Cover Installation below.
Hex Bolt Assembly
Lock
Washer
Flat Hex
Washer Bolt
Swing Hanger Cover Instructions:
1. Insert flexible Swing Hanger Cover over hook.
2. Slide Swing Hanger Cover around hook until at top.
3. Hook swing rope onto hook.
4. Twist and flex Swing Hanger Cover onto open end of hook.
1
Step 16 Attach Swing Asy and Swings
T-Nut
Fig. 18.2
T nut
Lock
nut
Flat washer
2
G5
1 x 5/16 x 4-1/2" Hex Bolt
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
GL8
1 x 5/16 x 2" Hex Bolt
(5/16" flat washer x 2, 5/16" lock nut)
Step 16 Attach Swing Asy and Swings
A31
Lock washer
G5
Flat washer
GL8
Flat washer
3
Hardware
33
Belt Swing
Fig. 18.1
4
Other Parts
2 x Belt Swing
4 x Swing Hanger Covers