KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 36

Step 21: Attach Ground Stakes
Warning! Check entire play centre for
bolts protruding beyond T-Nuts. Use
extra washers to eliminate this condition.
A: Drive 1 (A36) Ground Stake 10-1/2" into the ground at each (A35) SW Post on the inside of the assembly and
attach with 2 (S3) #8 x 2-1/2" Wood Screws per ground stake. (fig. 21.1 & 21.2)
B: Drive 1 (A36) Ground Stake 10-1/2" into the ground beside the 2 (A20) Corner Posts shown in fig. 21.1, on the
inside of the assembly and attach with 2 (S3) #8 x 2-1/2" Wood Screws per ground stake. (fig. 21.1 & 21.3)
C: Inspect for open 3/8" holes. Insert Hole Plugs into all unused holes. (fig. 21.4)
Step 19 Ground Stakes
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 10-1/2" into ground.
Digging or driving stakes can be dangerous if you
do not check first for underground wiring, cables
STEP 19 Attach Slide and Acro Swing
or gas lines.
A35
S3
10-1/2"
Fig. 21.2
Wood Parts
4 x Ground Stakes 1-1/4 x 1-1/2 x 14"
A36
Fig. 21.1
A35
A36
A36
8 x
A36
S3
Fig. 21.3
Hardware
S3 #8 x 2-1/2" Wood Screw
36
If Bolt protrudes
beyond T-Nut
Use an extra
Flat Washer
A20
A20
Fig. 21.4
A36
Other Parts
4 x Hole Plugs