KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 18

Step 5: Left Wall Assembly
Pre-drill all pilot holes using a
1/8" drill bit before installing
the lag screws.
A: To the 2 remaining (A20) Corner Posts attach 1 (A25) Lower Side and 1 ( A14) SW Floor with 4 (H2) 1/4 x 2"
Hex Bolts (with lock washer, flat washer and t-nut) per board and 1 (A29) Side Top with 2 (H2) 1/4 x 2" Hex Bolt
(with lock washer, flat washer and t-nut) in the top holes. (fig. 5.1) Be sure to keep bolts loose.
B: Make sure assembly is square and then in the bottom holes of the (A29) Side Top fasten to each (A20) Corner
Post using 2 (S2) #8 x 1-1/2" Wood Screws. (fig. 5.1)
C: Attach (A12) Lower Diagonal to (A25) Lower Side with 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer
Step 2 Left Wall Asy
and t-nut). Make sure assembly is still square and then attach to (A20) Corner Post using 1 (LS3) 1/4 x 3" Lag
Screw (with flat washer). (fig. 5.1)
D: Attach 1 (A18) Corner Block flush to the end of (A25) Lower Side with 2 (S2) #8 x 1-1/2" Wood Screws. (fig.
5.1)
A12
H2
Wood Parts
2 x Corner Post 2 x 4 x 83"
A20
1 x Lower Side 1 x 5 x 62-3/8"
A25
1 x SW Floor 1 x 6 x 26-7/8"
A14
1 x Side Top 1 x 4 x 51-1/2"
A29
1 x Lower Diagonal 2 x 3 x 37"
A12
Predrill Pilot Holes for Lag Screw
Lag
Screw
Flat
Washer
Fig. 5.1
LS3
A25
A18
1 x Corner Block 2 x 3 x 4-1/2"
A18
Predrill 1/8"
pilot hole
Use factory drilled
hole as a guide
H2
A20
A14
Notice hole
location
S2
Hardware
11 x 1/4 x 2" Hex Bolt
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
S2
4 x #8 x 1-1/2" Wood Screw
1 x 1/4 x 3" Lag Screw (with 1/4" flat washer)
LS3
18
Hex Bolt Assembly
Lock
Washer
Flat Hex
Washer Bolt
H2
S2
A29
S2
A20
H2
T-Nut