KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 16

Step 3: Attach Swing End to Swing Beam
A: Place (A32) SW Rail Block in the centre between (A1) CE SW Beam Back and (A2) CE SW Beam Front and
attach with 1 (H8) 1/4 x 4-1/4" Hex Bolt (with lock washer, flat washer and t-nut). (fig. 3.1 & 3.2)
B: Attach Swing Beam Assembly to the side of the Swing End Assembly with the overhang (fig. 3.3 & 3.4) using 1
(G5) 5/16 x 4-1/2" Hex Bolt (with lock washer, flat washer and t-nut) in the top hole of Triangle Plate and 1 (GL8)
5/16 x 2" Hex Bolt (with 2 flat washers and lock nut) in the bottom hole of Triangle Plate. (fig. 3.3) Make sure
Swing End Assembly flares out at an angle.
Hex Bolt Assembly
Lock
Washer
Flat Hex
Washer Bolt
Fig. 3.1
Step 14 Swing Asy B
Step 14 Swing Asy B
Fig. 3.4
Wood Parts
1 x SW Rail Block 2 x 4 x 5-3/8"
A32
T-Nut
100°
Fig. 3.2
Side with
Overhang
Hardware
H8
1 x 1/4 x 4-1/4" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
G5
1 x 5/16 x 4-1/2" Hex Bolt
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
GL8
1 x 5/16 x 2" Hex Bolt
(5/16" flat washer x 2, 5/16" lock nut)
16
A1
A32
A2
H8
Fig. 3.3
G5
GL8