KidKraft MEADOWVALE II Installation And Operating Instructions Manual page 35

Step 20: Attach Slide and Acro Swing
Note: Pre-drill all holes using a 1/8" drill bit before installing the pan screws.
A: Place Slide in the centre between (A20) Corner Post and (A13) Centre Divider. (fig. 20.1)
B: Pre-drill 1/8" pilot holes and attach slide to fort through (A21) SL Spacer using 3 (S7) #12 x 2" Pan Screw. (fig.
20.2 & 20.3)
C: Attach Acro Swing to the end of (A23) Acro Top making sure the knot is tight and secure. The spacing between
the Acro Swing and (A23) Acro Top should be no less than 10". (fig. 20.1 & 20.4)
Step 18 Attach Slide & Acro Swing
D: Secure the Acro Swing ropes with 2 Cable Ties per rope. Be sure to trim the Cable Tie excess and round off
any sharp edges. (fig. 20.4)
A20
Step 18 Attach Slide & Acro Swing
Fig. 20.2
Fig. 20.3
A21
End of slide is
flush to A21
S7
A13
A21
Fig. 20.1
1"
between
cable ties
Secure with cable ties. Trim excess
cable ties and round sharp edges.
Hardware
3 x #12 x 2" Pan Screw
S7
35
Acro swing spacing should
be no less than 10"
A23
Fig. 20.4
Other Parts
1 x Acro Swing
4 x Cable Ties
1 x Slide (sold separately)
10"