Optional Serial Com Port; Removing The Optional Serial Com Port - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 36. Installing the intrusion switch
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Optional serial COM port

Removing the optional serial COM port

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Disconnect and remove the serial COM port cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Lift the serial COM port module out of the system.
After working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 47