System Board; Removing The System Board - Dell EMC PowerEdge R750xs Installation And Service Manual

Steps
1. Align the slots on the PIB with the hook on the system and slide it into place.
2. Using Phillips #2 screwdriver, tighten the screws to secure the PIB to the system.
Figure 125. Installing the power interposer board
3. Reconnect all the required cables.
Next steps
1. Install the PSU.
2. Install the air shroud.
3. Follow the procedure listed in

System board

This is a service technician replaceable part only.

Removing the system board

Prerequisites
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a. System cover
b. Air shroud
c. Cooling fan cage
d. Expansion cards
e. Expansion card risers
After working inside the system.
Safety instructions.
Before working inside your system.
Installing and removing system components 125