Figure 107. Installing the rear mounting front PERC module
Next steps
1.
Install the cooling fan
2. If removed,
install the air
3.
Install the drive backplane
4. Follow the procedure listed in
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables that are connected to the PERC, observe the cable routing.
NOTE:
The front mounted front PERC module is only shipped with 8 x 3.5-inch SAS/SATA backplane configuration.
Steps
1. Using a Phillips #2 screwdriver, loosen the two captive screws on front mounted front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
cage.
shroud.
cover.
After working inside the
Safety
Before working inside your
system.
instructions.
system.
Installing and removing system components
109