Processor And Heat Sink Module; Removing The Processor And Heat Sink Module - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 64. Installing a memory module
Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System
BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of
the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
5. Run the system memory test in system diagnostics.

Processor and heat sink module

This is a service technician replaceable part only.

Removing the processor and heat sink module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
NOTE: The heat sink and processor are too hot to touch for some time after the system has been powered down. Allow
the heat sink and processor to cool down before handling them.
Steps
1. Ensure all four anti-tilt wires are in the locked position (outward position), and then using a Torx #T30 screwdriver, loosen
the screws on the heat sink in the order that is mentioned below:
a. Loosen the first screw completely.
b. Loosen the screw diagonally opposite to the screw you loosened first.
c. Repeat the procedure for the remaining two screws.
2. Set the anti-tilt wires to the unlocked position (inward position).
72 Installing and removing system components
After working inside the system.
Safety instructions.
Before working inside your system.