Installing The Drive Backplane - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 49. Removing the drive backplane
Next steps
Replace the drive backplane.

Installing the drive backplane

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the drive backplane
5. Remove all the drives.
NOTE: To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Use the hooks on the system as guides to align the slots on the backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tabs click into place.
Safety instructions.
Before working inside your
cover.
system.
Installing and removing system components 57