Removing Expansion Card From The Expansion Card Riser - Dell EMC PowerEdge R750xs Installation And Service Manual

Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Disconnect the expansion card cables from the system board and remove the expansion card riser.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
Figure 84. Removing an expansion card from the Riser 1A
92 Installing and removing system components
After working inside the system.
Safety instructions.
Before working inside your system.