Removing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 105. Installing the adapter PERC
3. Insert the adapter PERC in the slot 1 of the system board.
Next steps
1. If removed, install the air
2. Follow the procedure listed in

Removing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. Remove the air shroud.
5. Remove the cooling fan
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on rear mounted front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
shroud.
After working inside the
Safety instructions.
Before working inside your
cover.
cage.
system.
system.
Installing and removing system components 107