Figure 88. Installing the expansion card in the Riser 1A
Figure 89. Installing the expansion card in the Riser 1B
Next steps
1. Reconnect the expansion card cables to the system board.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the system;
the new card automatically updates to the same firmware and configuration of the faulty one. For more information about
the Part replacement configuration, see the Lifecycle Controller User's Guide at
After working inside the
system.
https://www.dell.com/idracmanuals
Installing and removing system components
95