Installing The Intrusion Switch - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 35. Removing the intrusion switch module
Next steps
Replace the intrusion switch

Installing the intrusion switch

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
46 Installing and removing system components
module.
Safety instructions.
Before working inside your system.