Installing The Front Mounting Front Perc Module - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 108. Removing the front mounting front PERC module
Next steps
Replace the front mounting front PERC module

Installing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE: The front mounted front PERC module is only shipped with 8 x 3.5-inch backplane configuration.
110 Installing and removing system components