Removing The Right Control Panel - Dell EMC PowerEdge R750xs Installation And Service Manual

Next steps
1. Replace the cooling fan cage
2. Replace the air shroud.
3. Replace the drive backplane
4. Follow the procedure listed in the

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. Remove the air shroud.
Steps
1. Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable
clip.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
3. Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
132 Installing and removing system components
assembly.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
system.
system.