Figure 111. Installing the rear drive module
2. Fasten the captive screw using the Phillips #2 screw driver.
3. Connect the power cable and signal cables to the rear drive module.
Next steps
1. If removed,
Install the cooling fan
2. If removed,
install the air
3. Follow the procedure listed in
Optional OCP card
Removing the OCP shroud
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
Hold the edges of the OCP shroud and lift the shroud at an angle out of the system.
cage.
shroud.
After working inside the
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
113