Installing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R750xs Installation And Service Manual

Figure 106. Removing the rear mounting front PERC module
Next steps
Replace the rear mounting front PERC module

Installing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air
5. Remove the cooling fan
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
108 Installing and removing system components
Safety instructions.
Before working inside your
cover.
shroud.
cage.
system.