Installation Of Ip54-Ready Devices; Figure 15: Installation Of Ip54-Ready Devices - KEB COMBIVERT F6 Series Instructions For Use Manual

DIMeNSIONS AND WeIGHTS

3.4.7 Installation of IP54-ready devices

①
②
③
④
Figure 15:
IP20 zone
IP54 zone
KEB COMBIVERT
Housing (e.g. control cabinet wall)
Installation of IP54-ready devices
IP54 zone: Heat sink outside the housing
The protection class IP54 can only be achieved when the device is properly
installed.
For proper installation, a suitable IP54 seal
(=> „4.3.2 Seal for IP54-ready
and housing (e.g. control cabinet wall).
The tightness must be checked after the installation. If properly installed, the
separation to the housing corresponds to degree of protection IP54.
IP20 zone: Device inside the housing
This part is intended for the installation in a suitable housing for the required
degree of protection (e.g. control cabinet).
The power connections are excluded =>
tions".
UL: Device heat sink is classified as NEMA type 1
②
①
③
④
devices") must be installed between heat sink
„3.1.1 Climatic environmental condi-
53