Product Features - KEB COMBIVERT F6 Series Instructions For Use Manual

PrODUcT DeScrIPTION

2.3 Product features

This instruction manual describes the power circuits of the following devices:
Device type:
Series:
Power range:
Housing
The COMBIVERT F6 is characterized by the following features:
•
•
•
•
•
•
•
•
•
•
•
•
Drive controller
COMBIVERT F6
45...90 kW / 400 V
6
Operation of three-phase asynchronous motors and three-phase synchronous
motors, in operating modes open-loop or closed-loop with and without speed
feedback
following fieldbus systems are supported:
EtherCAT, VARAN, PROFINET, POWERLINK or CAN
System-overlapping operating concept
Wide operating temperature range
Low switching losses by IGBT power unit
Low noise development due to high switching frequencies
Different heat sink concepts:
Temperature-controlled fan, easily replaceable
Torque limits and s-curves are adjustable to protect gearboxes
General protection functions of the COMBIVERT series against overcurrent, over-
voltage, ground fault and overtemperature
Analog inputs and outputs, digital inputs and outputs, relay output (potential-free),
brake control and -supply, motor protection by I²t, KTY- or PTC input, two encod-
er interfaces, diagnostic interface, fieldbus interface (depending on the control
board)
Integrated safety function according to
EN 61800-5-2
23