Direct Port Access; Custom Menus - Digi Connectware CM User Manual

Direct Port Access

Users can connect directly to a properly configured port through a Telnet or
SSH session. Configuration requirements include setting the Host Mode to
Console Server Mode and the Protocol to either Telnet or SSH. Ports, by
default are set to Console Server Mode and Telnet. Use the information that
following to make a Telnet or SSH connection to a port:
Type
Telnet
SSH

Custom Menus

Custom menus are created by either root or the system administrator to limit a
user's access to specific ports. For more information, see "Making Custom
Menus" on page 59.
Chapter 1
Command Syntax
telnet ip-address tcp-port
where ip-address is the Digi CM's IP
address and tcp-port is the Listening
TCP port for a port
ssh user-name@ ip-address tcp-port
where user-name is a user's name, ip-
address is the Digi CM's IP address and
tcp-port is the Listening TCP port for a
port
Note: The example assumes that the Listening TCP port is 7003, the default for port 3.
Example: Connection to Port
3
telnet 192.168.15.7 7003
ssh admin@ 192.168.15.7 7003
Introduction
13