Chapter 2 Getting Started; Introduction; Assigning Ip Settings From The Console Port - Digi Connectware CM User Manual

Chapter 2

Introduction

This chapter covers basic configuration topics. Included is information on
assigning IP settings, enabling secure access with the web interface,
accessing the unit through SSH, and adding and removing users.

Assigning IP Settings from the Console Port

To use the console port to assign IP settings, do the following:
1. Connect the console port on the rear panel of the Digi CM to a serial port
The default IP
address is
192.168.161.5.
2. Configure a terminal emulation program, such as HyperTerminal, using the
3. Establish a connection to the console port and press Enter to get a com-
4. At the login prompt, log in as admin. The default passwords for admin is
5. Enter the following to navigate to the IP configuration:
Chapter 2
Note: Initial setup is described in the Quick Start Guide included with the product pack-
aging. A copy of this document is also available online at http://cm.digi.com.
on a workstation using the Ethernet console cable and DB-9 adapter pack-
aged with the Digi CM. The arrow in the following graphic points to the
console port.
following settings: bps=9600, data bits=8, parity=none, stop bits=1, and
flow control=none.
mand prompt.
admin.
The Configuration menu appears.
a. 1 for Network configuration
b. 1 for IP configuration
c. The numbers for the individual IP settings.
The following menu is displayed.
Getting Started
G e t t i n g S t a r t e d
console port
15