Configuring Http And Https - Digi Connectware CM User Manual

Configuring HTTP and HTTPS

.
6. Press ESC when done to return to the main configuration menu.
7. Enter number 9 to exit and apply changes.
Configuring HTTP and HTTPS
By default HTTP and HTTPS are enabled on the Digi CM device. To modify
these settings, do the following:
1. Enter the IP address for the Digi CM in a web browser's URL.
2. Choose Web server configuration from the Network Configuration heading
3. Choose Enabled or Disabled.
4. Set the desired refresh rate for statistics data. The default value is 10 sec-
5. Choose an authentication method for accessing the web interface. The
6. To save and apply changes, choose Save & apply.
16
Changes are saved and applied immediately. There is no need to reboot.
on the web interface menu.
onds.
default is local.
Chapter 2