Using The Configuration Menu - Digi Connectware CM User Manual

Using the Configuration Menu

Using the Configuration Menu
Firmware Upgrade
Before upgrading firmware from the configuration menu you should have:
•
•
To upgrade the firmware with the configuration menu, do the following:
1. Access the configuration menu.
2. Choose System administration.
3. Choose Firmware upgrade. Enter y for Yes when asked if you want to
If the firmware upgrade is successful, the Digi CM will reboot automatically. If a
Firmware upgrade failed! warning appears, do not reboot the unit but repeat
the upgrade process.
Restoring Factory Defaults
You have two choices to restore the unit to its factory defaults. The options are
restoring all factory defaults or restoring all factory defaults except IP settings.
To restore your unit to the factory defaults, do the following:
1. Access the configuration menu.
2. Choose System administration.
3. Choose either Reload factory default settings or Reload factory default set-
4. Enter y for yes when asked to Reload the default settings.
84
Downloaded the firmware to a system on the same subnet
Set up a terminal emulation program that supports Zmodem transfer proto-
col
upgrade the firmware.
tings except IP settings.
Chapter 12