Table of Contents
Advertisement
Chapter 15
Safety
•
•
•
Working Inside the Digi CM
NOTICE: Do not attempt to service the Digi CM yourself, except when
following the instructions from Digi Technical Support personnel. In such a
case, first perform the following actions:
•
•
Replacing the Battery
A coin-cell battery maintains date and time information. If you have to
repeatedly reset time and date information after turning on your Digi CM,
replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the
3 Volt CR2032 battery only with the same or equivalent type recommended by
the battery manufacturer. Discard used batteries according to the battery
manufacturer's instructions.
Safety Instructions
CAUTION: Do not operate your Digi CM with the cover removed.
•
•
•
•
Chapter 15
US: UL1950
Canada: CSA 22.2 No. 60950
Europe: EN60950 (CB Scheme Report)
Turn off the Digi CM.
Ground yourself by touching an unpainted metal surface at the back of the
equipment before touching anything inside your equipment.
To avoid shorting out your Digi CM when disconnecting the network cable,
first unplug the cable from the equipment and then from the network jack.
When reconnecting a network cable to the equipment, first plug the cable
into the network jack and then into the equipment.
To help prevent electric shock, plug the Digi CM into a properly grounded
power source. The cable is equipped with 3-prong plug to help ensure
proper grounding. Do not use adapter plugs or remove the grounding
prong from the cable. If you have to use an extension cable, use a 3-wire
cable with properly grounded plugs.
To help protect the Digi CM from transients in electrical power, use a surge
suppressor, line conditioner, or uninterruptible power supply.
Be sure that nothing rests on Digi CM cables and that the cables are not
located where they can be stepped on or tripped over.
Certifications
C e r t i f i c a t i o n s
101
Advertisement
Table of Contents
