Placement of Module
Port Descriptions
The development board provides the following ports:
See the figure titled "Board Layout and Connector Locations:" on page 15 for the location of the
ports. The following sections describe the ports.
Primary Serial Port, P1
The Primary Serial Port is a DB-9 male connector that is labeled as P1 on the development board.
See the following figure for pin orientation; see the following table for pin assignments.
Caution: When handling the development board, wear a grounding wrist
strap to avoid ESD damage to the board.
Primary Serial Port, P1
Secondary Serial Port, P2
GPIO Port, P7
1 7