Using The Configuration Menu - Digi Connectware CM User Manual

Using the Configuration Menu

user when the host mode is configured for dial-in modem or dial-in terminal
server mode.
Inter-character Timeout
This setting is only available when the host mode protocol is set for RawTCP.
The parameter sets the time value for the Digi CM to transfer data stored in the
buffer. The Digi CM transfers data when the buffer is full using the TCP/IP
protocol. However, if it is not full, the Digi CM will also transfer data dependent
on the timeout value selected.
Using the Configuration Menu
Host Mode Configuration
1. Access the configuration menu.
2. Choose Serial port configuration > an individual port number or 0 (zero) for
3. Enter the desired parameters for each menu item.
4. Use the ESC key when all parameters are entered to return to the main
5. Choose Save changes.
Port Parameters
1. Access the configuration menu.
2. Choose Serial port configuration > an individual port number or 0 (zero) for
3. Enter the desired parameters for each menu item.
32
all ports > Host mode configuration.
menu.
all ports.
Chapter 4