Table of Contents
Advertisement
Port Clustering
Using the Configuration Menu
Clustering
By default clustered slave devices are configured using the Telnet protocol and
port parameters of the following: bps=9600, data bits=8, parity=none, stop
bits=1, flow control=none. When the master device autoconfigures a slave
device, it simply imports the information from the slave unit. If you want other
protocols or other port parameters, you should configure your slave unit first
with those parameters before autoconfiguring.
Before you start this configuration procedure, the slave units should already be
configured unless you want them set to the default values. To set up the Digi
CM for clustering, do the following:
1. Access the configuration menu.
2. Choose Clustering configuration > Unit position.
3. Assign the unit as the master device.
A new screen is displayed.
4. Enter the number 1 for the first slave unit.
5. Choose Enable/Disable unit clustering > Enable.
6. Enter the values for Slave Unit IP, No. of ports, and Port configuration.
7. Choose ESC to return to the main menu.
8. Choose Exit and apply changes.
Chapter 10
75
Advertisement
Table of Contents
