Command And Response Table For Sis Commands - Extron electronics DTP3 T 202 User Manual

Command and Response Table for SIS Commands

Command
Signal Status (unsolicited)
Request all signal status (Tx)
Request all signal status (Rx)
X!
KEY:
= Signal Status:
HDCP Status (unsolicited)
View input HDCP status
View output HDCP status (Tx)
View Output HDCP status (Rx)
X&
KEY:
= Input HDCP Status:
X*
= Output HDCP Status:
HDCP Authorized Device (Tx only)
HDCP authorization enable/
disable
HDCP authorization status
KEY: X!
= Authorization status:
HDCP Output Mode (on Tx, applies to both outputs simultaneously)
Set output HDCP mode all
outputs
View status
X(
KEY:
= HDCP output mode
1
= (Default) Encrypt as required by input. Continuous trials for HDMI sinks, attempt for 10s on DVi sinks (then fail).
2
= Always encrypt. Continuous trials for HDMI sinks, attempt for 10s on DVI sink (then fail).
EDID (Tx only)
View input EDID in HEX format
View input EDID native rate
KEY: X1!
= 128 or 256 Byte EDID raw HEX (text form) from currently assigned EDID.
X1@
= Native resolution and refresh rate from currently assigned EDID, for example: 1920x1080 @ 60 Hz.
Remote Send Power Switch
Send Power switch status
KEY: X@
= Remote power:
ASCII command
(host to device)
E }
LS
Verbose mode 2/3
E }
LS
Verbose mode 2/3
0 1
= Off/Disabled = On/Enabled
E }
IHDCP
Verbose mode 2/3
E }
OHDCP
Verbose mode 2/3
E }
OHDCP
Verbose mode 2/3
0
= No video/source detected
2
= Video/source detected, with HDCP
0
= No sink detected
2
= Sink detected, output HDCP encrypted
E X! }
E HDCP
E }
EHDCP
Verbose mode 2/3
0 1
= Disabled = Enabled (default)
E X( }
S HDCP
E }
SHDCP
Verbose mode 2/3
E }
REDID
E }
NEDID
E }
RPWR
Verbose mode 2/3
0
= Remote power disabled
Response
(device to host)
*
X! X! • X!]
X! X! • X!]
Sig *
*
X! X!]
X! X!]
Sig *
X&]
X&]
HdcpI
X* • X*]
X* • X*]
HdcpO
X*]
X*]
HdcpO
1
= Video/source detected, without HDCP
1
= Sink detected, output not HDCP encrypted
X!]
HdcpE
X!]
X!]
HdcpE
X(]
HdcpS
X(]
X(]
HdcpS
X1!]
X1@]
X@]
X@]
Rpwr
1
= Remote power (48 VDC) enabled
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
Additional
description
Input*Outputs 1-2
Input*Output
Hex data from EDID
assigned to input.
Native rate of EDID
assigned to input.
19