Receiver Rear Panel Connections - Extron electronics DTP3 T 202 User Manual

nt Panel
SEND
PWR HDBT INPUT
SIGNAL
HDCP
OFF DTP DTP3 T 202
C D E

Receiver Rear Panel Connections

ar Panel
SIG LINK OVER
TP
RS-232
Tx Rx G
PUT OUT
C D E
Output RJ-45 port — Connect one end of a TP cable to this RJ-45 port on the
D
transmitter. Ensure the opposite end of this cable is connected to the receiver DTP3 In
RJ-45 port (see figure 3,
Signal LED — This green LED indicates the unit is receiving a TMDS clock signal
•
on the HDMI input.
• Link LED — This amber LED indicates a valid link is established between the
transmitter and the receiving device.
ATTENTION:
DTP3 R 201 Front Panel
Do not connect these devices to a telecommunications or computer data
•
network.
• Ne connectez pas ces appareils à un réseau de télécommunications ou de
données informatiques.
CONFIG
e
NOTE: See TP Cable Termination and Recommendations
properly wire the RJ-45 connectors.
A B
Over TP port — Connect a serial RS-232 signal to this 3.5 mm, 3-pole captive screw
E
port for bidirectional RS-232 communication (see
page 11 to wire the connector).
DTP3 R 201 Rear Panel
POWER
HDMI
12V
--A MAX
OUTPUT
A B
Figure 3. DTP3 R 201 Receiver Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2-pole
A
inlet or the power inlet on the transmitter (see
Supply Wiring on page 9 to wire the connector).
NOTES:
One power supply is included with the transmitter and can normally power
•
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP3 series.
The power supply can be plugged into either the transmitter or the receiver to
•
power both units.
HDMI output — Connect a display with an HDMI input port (or DVI input port, with an
B
appropriate adapter) to display the transmitted digital image.
NOTE: See Securing the HDMI Connector
the HDMI connectors to the transmitter and the receiver.
DTP3 In port — Connect one end of the TP cable from the transmitter output to
C
this RJ-45 port. Ensure the opposite end of this cable is connected to the transmitter
Output port (see figure 2,
• Signal LED — This green LED indicates the unit is receiving a TMDS clock signal
on DTP3 In port.
).
C
SEND
DTP
PWR
SIGNAL
HDCP
OFF
DTP3 R 201
C D
RS-232 Connector Wiring
SIG LINK OVER
L R
DTP3
RS-232
Tx Rx G AUDIO OUT
DTP3 IN
C D E
figure 2,
on the next page to securely fasten
on page 5).
D
DTP3 T 202 / DTP3 R 201 • Installation and Operation
on page 8 to
on
Power inlet
A
HDMI output port
B
DTP3 IN RJ-45 port
C
Over DTP3 RS-232 port
D
Audio output
E
on page 5, and Power
A
6