Installing Cables In The Attachment Shaft; Tips For Opening The Attachment Shaft; Notes Regarding Changes To The Attachment Shaft; Note For Closing The Attachment Shaft - B&R Mobile Panel 40 User Manual

3.3.2 Installing cables in the attachment shaft

After opening the attachment shaft, the connecting lines

3.3.2.1 Tips for opening the attachment shaft

• Place the Mobile Panel
damage the Mobile Panel or its operating elements (e.g.
• Loosen the screws with a size 2 Phillips head screwdriver.

3.3.2.2 Notes regarding changes to the attachment shaft

• Disconnect the main connector (ST1) by pulling carefully on its wires with your fingers (do not use sharp
objects to help).
• When disconnecting the RJ45 connector (ST2), make sure that the locking lever is pushed down.
ST1
• Make sure that the connector locks into place.

3.3.2.3 Note for closing the attachment shaft

• The gasket must be clean, undamaged and positioned correctly in the attachment shaft cover.
• Pinched cables are not permitted.
• The attachment shaft cover must be refastened with all 6 screws (torque: 0.4 to 0.5 Nm). Only then
the corresponding degree of protection be ensured again.

3.3.3 Cable outlet

Mobile Panel 40/50 User's manual V1.80
device on a clean flat surface with the display facing down in a away that does not
ST1
Figure 43: Disconnecting ST1 and ST2
Ethernet cable
Cable outlet - Right
(cable duct view)
Figure 44: Cable outlet
can be installed as shown in the following section.
ESD mat).
1
ST2
2
Cable outlet - Left
(cable duct view)
Commissioning
can
69