Control Cabinet Cables - B&R Mobile Panel 40 User Manual

Technical data
2.3.2.2 Control cabinet cables
2.3.2.2.1 5CAMPC.0020-10
2.3.2.2.1.1 General information
A crossover control cabinet cable is required for the wiring inside the
The pinout of the crossover
X20) or the 1st Ethernet interface
If a different Ethernet hub
Stop / Emergency stop (6 wires)
2 wires not used
Enable switch (6 wires)
2 wires not used
RS232 (3 wires)
Not used
CAN + shield (5 wires)
Not used
Information:
A control cabinet cable is used for the Mobile Panel 7100, Mobile Panel 40/50 and Mobile Panel 100/200
product series. Not all wires are used when wiring Mobile Panel 7100 and Mobile Panel 40/50 devices,
which limits their functionality compared to Mobile Panel 100/200 devices.
The surface is protected against water, oil (lubricating and hydraulic oils per
lubricant.
The control cabinet cable is fastened to the
- Drilling template" on page
connector. The remaining lines have an open end with wire end sleeves to make it easier to wire to
and other interfaces.
2.3.2.2.1.2 Order data
Model number Short description
Control
5CAMPC.0020-10 Mobile Panel
-
Optional accessories
Accessories
4MPCBX.0000-00 Mobile Panel connection box - For cables with push-pull circular
connectors
4MPCBX.0000-C01 SIT MP connection box PP
4MPCBX.0001-00 Mobile Panel small connection box - For cables with push-pull
circular connectors
2.3.2.2.1.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for these individual
components and may differ from those of the complete system. The data specified for the complete
system applies to the complete system in which this individual component is used, for example.
Model number
General information
Certifications
CE
GOST-R
Cable construction
Type
60
Ethernet connector makes it possible to connect it directly to a B&R
(MDIX) on B&R
is used, it must support crossed over RX and TX lines.
Power supply
+ grounding
(3 wires)
Ethernet RJ45 +
Shield (4 wires)
Figure 36: 5CAMPC.0020-10 - Mobile Panel
control
62). The other end of the
cabinet cables
control cabinet cable - Push-Pull circular connector
Ethernet crossover - 2 m
Table 24: 5CAMPC.0020-10 - Order data
Table 25: 5CAMPC.0020-10 - Technical data
control
Ethernet hub AC808.
control
cabinet door via the connection housing
control cabinet cable has a pre-assembled RJ45
5CAMPC.0020-10
Crossover
cabinet.
Receptacle
for push-pull locking mechanism
cabinet cable
EN 60811 Part 2-1) and cooling
(see Fig. 38 "Receptacle
safety
Figure
Yes
Yes
Mobile Panel 40/50 User's manual V1.80
controller (e.g.
Ethernet
equipment