Installing Interface Modules; Touch Screen Calibration; Screen Rotation - B&R 4PP065.0571-B00 Technical Documentation Manual

Commissioning

4.3 Installing interface modules

①
⑤
④
②
③
Table 16: Installing PP65 interface modules in the Power Panel 65
1) Remove the screws from the cover.
2) Remove the cover.
3) Insert the interface module into the PP65.
4) Apply light pressure until the interface module is inserted all the way.
5) Secure the interface module with the screws (max. 0.6 Nm).

4.4 Touch screen calibration

B&R touch screen devices are equipped with a touch controller that supports hardware calibration. As a result,
devices are pre-calibrated when delivered. This is an advantageous feature when replacing devices of the same
model or type since it avoids having to recalibrate the new device. Nevertheless, calibrating the device is still
recommended in order to achieve the best results and to better adapt the touch screen to the user's preferences.

4.5 Screen rotation

It is possible to rotate screen contents by 90° using the graphic driver's screen rotation function. Automation Run-
time supports this function.
In Automation Studio 2.7.x or 3.0.x, the screen orientation can be defined when a project is created as well as
later when editing the project.
22 Data sheetV 1.00 4PP065.0571-B00