B&R Mobile Panel 40 User Manual page 65

Connection housing - Pinout
1
2
15
16
18
26
Receptacle - Pinout
3
14
17
Connection housing - Pinout
27
28
29
30
Ethernet shield
Connection housing - Pinout
10
11
12
13
CAN shield
Information:
When installing the
cabinet.
2.3.2.2.2.5 Receptacle - Drilling template
A cutout or drill hole must be made (e.g. in a
the receptacle.
Mobile Panel 40/50 User's manual V1.80
Control cabinet cable - Wire colors
Gray-Pink
Brown-Green
White-Green
Red-Blue
Yellow
Green
Control cabinet cable - Wire colors Power supply wires
Red
Black
Gray
Control cabinet cable - Wire colors
Green
Pink
Yellow
Blue
Shielding
Control cabinet cable - Wire colors
White
Orange
Yellow
Green
Black
Table 29: 5CAMPC.0020-11 - Cable pinout
control cabinet cable, make sure that it is not too loose or too tight in the
control
Marking point
Outline of
Slotted nut
Figure 41: Receptacle - Drilling template
Control device wires
Stop / Emergency stop normally closed contact 1 (11)
Stop / Emergency stop normally closed contact 2 (21)
Stop / Emergency stop normally closed contact 1 (12)
Stop / Emergency stop normally closed contact 2 (22)
Button (S13)
Button (S14)
+24 VDC power supply
Ground
Shielding
Ethernet RJ45 connector
Pin 1 (TX)
Pin 3 (RX)
Pin 2 (TX\)
Pin 6 (RX\)
Shielding
CAN wires
CAN 1 High
CAN 1 Low
CAN 2 High
CAN 2 Low
Shielding
cabinet door) according to the following diagram to fasten
Cutout
28.6
Technical data
Not used on the MP40/50
control
65