Installing The Buffer Accumulator - B&R Mobile Panel 40 User Manual

Servicing/Maintenance

7.2 Installing the buffer accumulator

Information:
The Mobile Panel is not permitted to be connected to a connection box or
1. Disconnect the power supply to the Mobile Panel.
2. Remove the cover of the attachment shaft on the rear side by removing the 6 marked screws (Phillips screw-
driver).
3. Connect the accumulator cable to the marked female connector and place the accumulator into position (as
shown in the image). Be sure that the cables are installed properly to prevent them from becoming pinched.
4. Install the cover.
128
Figure 83: Removing the cover of the attachment shaft
Figure 84: Connecting the cables
control cabinet.
Mobile Panel 40/50 User's manual V1.80